Embedded Files
Hello and welcome! This site will be for people to get caught up to speed on the inflatable toys I make so you can decide if you want to buy one for yourself! I also have a Twitter I will post on as well (https://twitter.com/ZoranToys) along with other things such as polls on what to make and squeakafying lucky folks and each toy will have a dedicated telegram channel and group for updates!
Hello and welcome! This site will be for people to get caught up to speed on the inflatable toys I make so you can decide if you want to buy one for yourself! I also have a Twitter I will post on as well (https://twitter.com/ZoranToys) along with other things such as polls on what to make and squeakafying lucky folks and each toy will have a dedicated telegram channel and group for updates!
Zoran the dino
Zoran the dino
As my first solo project I present my sona Zoran complete with his trademark Monkey diaper that is removable! He is about 76''-77'' tall [193.04 CM -195.58 CM]. Zoran is a 2 chamber toy with one on his tail and on his back but is very unusual in that the tail inflates the lower half of his body and the back one the top half. Both of his valves are double #3s while his diaper is a double #2. Originally I didn't want these as people report they don't hold air but it worked out better as inflation and deflation is much much easier and faster. As for the diaper I find it amusing they printed it on the inside and its made to fit the toy and i would assume its way to big to wear.( I intend on making a human sized one at a later time) the hole for the tail is about 15'' [38.1 CM] across which may fit fursuits but im not sure.
![The hole for the tail is 15''[38.1CM] across. Way too big for a person but i suppose perfect for wearing over a fursuit.](https://lh6.googleusercontent.com/xosErVXACdwjgQrwSj0__1GhykIBpV7uuNsHB8UH0hVNULqZUTkLgx2NWL8G4xO-8J0-Ymsoek3I6sgDkmNRt7k1xk_a_VkjUadzIH93PObU3FwRLcMYp_-0aCZuhfWbQw=w1280)
The things I don't like are as follows
1: The head shape I don't like at all. The company did it as close as they could to the ref sheet and I also assume there were limitations on their end or the tech so he looks like a vintage hair dryer
2: The amount of seams I dont like but its mostly in the head and again i chalk it up to limitations
3: The factory didn't cure the ink all the way and It stuck to other parts and came off and stained the claws badly. I can live with that on a proto but as a toy run that would be absolutely unacceptable
All in all I may go to a different company but as of now I will hang on tight and take a poll if if I should run this version or get his design tweaked a bit
Now lastly here is the poll.
Page updated
Google Sites
Report abuse